![]() ![]() The disklabel command can be used to change the drive identification or theĭisk partitions on the drive, or to replace a damaged label or bootstrap. The disk label contains information about theĭisk, such as type, physical parameters, and partitioning. The disklabel command can be used to install, examine, or modify the label WĚllows writing of the pack label area on the specified disk. w Writes a standard label on the designated drive. Specifies which type of the local file system the boot blocks s Sets the file system type ( fstype) field in the disk label. R Restores a disk label that was formatted in a prior operation and Operating on the in-memory copy of the label. r Reads or writes the label directly to or from the disk, rather than p Prints label parameters for the specified disk to stdout. Nĝisallows writing of the pack label area on the specified disk. n Writes an initial label to a disk which will then be labeled, but The cdfs default applies only when the -f The default imageįile type is cdfs, to indicate that the image file was created in ISOĩ660 Rock Ridge format. Specifies the type of image file for operations. sbin/disklabel disk /sbin/disklabel -z disk /sbin/disklabel -s partition fstype /sbin/disklabel -f image_ file /sbin/disklabel -f image_ file primary_ boot secondary_ boot /sbin/disklabel -e -f image_ file FLAGS -eĞdits an existing label. sbin/disklabel -e disk /sbin/disklabel -R disk protofile SYNOPSIS /sbin/disklabel disk /sbin/disklabel -p disk Click this button to go to the index for this section.ĭisklabel(8) NAME disklabel - Reads and writes disk pack label ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |